; PS/2 Configuration file for the Alloy HI-2 Bus Interface Card ; Version 1.00 03 2 AdapterID 077FFh AdapterName "Alloy HI-2 PC Expansion Bus Interface Card for the PS/2" NumBytes 4 ; All four available POS ports are used by this card. NamedItem ; Let's find out what's in the box. If we have just slaves, we'll only ; use the D000 window. If we have MainLine also, we'll use C000 and D000. ; In either event the access address range (A23-A20) is set to zero. Prompt "Contents of Expansion EJ>_>5!BeDee%!#5!FeHee#%!PR%.Be!ZXPR.Fe#%!ZX..Fe.>@eQY.@et..BeIBM HARDFILE TYPE 000 QSQRVWT%=tg0rQ@t QY`r26 Sr%@t QY 4r \_^ZY[˺$"<"t B-}PXP=Xr4P6Xr-. &rQGY.> t .> tSR3$ t [YXZW3$' ADAPTERIDADAPTERNAMENUe "Level 8" pos[1]=10XX1000b arb 8 choice "Level 9" pos[1]=10XX1001b arb 9 choice "Level 10" pos[1]=10XX1010b arb 10 choice "Level 11" pos[1]=10XX1011b arb 11 choice "Level 12" pos[1]=10XX1100b arb 12 choice "Level 13" pos[1]=10XX1101b arb 13 choice "Level 14" pos[1]=10XX1110b arb 14 choice "Level 15" pos[1]=10XX1111b arb 15 Help "This assignment should only be changed if the system indicates a conflict with another adapter. Conflicting assignments are marked with an asterisk. If you must change this assignment, you should try to change it to the lowest available number, as lower numbers have higher priorities. This priority value is used by the system." NamedItem ; Here we set up the interupt channel to use. One such channel is needed ; by the MainLine board. Which one is selectable. Prompt "Interrupt Channel to use" choice "IRQ 4" pos[0]=X0101111b choice "IRQ 6" pos[0]=X1001111b choice "none" pos[0]=X0001111b Help "An interrupt channel is needed to run MainLine. If this system has only slave boards, then you may choose 'none'. Otherwise, be sure that the MainLine hardware AND software are configured for the same channel that is selected here."